1 - INPUT SELECTOR KNOB :
With this knob you can select which input is to be activated for listening. The selected
input can be seen on the Display [2].
Pushing the knob will engage the MODE menu. While in the MODE menu, turning the
knob will scroll through the individual Menus. To exit the MODE menu, simply push the
knob once again.
2 –Display Input :
This display shows what input is currently selected and active. A small dot will light up
behind the display if the cinch-output [13] is set to a record output (see #4.4).
3 - LED :
This LED will light up once the stereo balance is turned more left.
4 – LED Power Indicator :
This LED will glow dimly as soon as the Snow White is set into Stanby mode. Receives
the preamplifier a signal from the remote control, this LED flashes to the beat of the
received signal.
5 – LED :
This LED will light up once the stereo balance is turned more right.
6 – Display Volume and MONO-Indicator :
This display shows the select volume level. It also displays other values when in the
MODE Menu
. This is more fully described in the MODE-Menu section (Chapter 4) below.
A small dot will light up behind the display if the MONO function is switches on.
7 –
Volume Knob
:
This knob is used to set and adjust the volume of the Snow White. If you push the knob,
you will engage the MONO operation and a small dot will light up behind the display [6].
The preamplifier will switch back to Stereo operation as soon as the Volume knob is
pushed or if the unit is switched into Standby.
8 –
On/Off (Standby) Button
:
This button is used to switch the unit On or Off (Standby). Once switched On, the LED [4]
will light up.
6
