cold environment into a warm room.
- The preamplifier should not be used when placed out in direct contact with the Sun.
-
Insure that the installation location for this product has adequate ventilation.
-
The preamplifier should not be doused with any type of liquid. It is imperative that no
liquid get inside the unit.
-
Never use this product without the shielded top cover installed.
-
Before removing the top cover always insure that the AC cord has been removed
from the AC outlet and that the product has sat to drain any residual current.
-
Never short any of the fuses. Replace broken fuses only with original fuses of the
same value and type.
-
Do not attempt to service this unit. Repairs are only to be done by authorized service
centers or through the factory direct. Any such unauthorized repairs will result in a
voided warranty.
-
Always make sure that your complete audio system is shut off before changing any
cables or connecting any other components.
The floor power supply of
SnowWhite II
is a switch mode version and operate at
main voltages between 100V to 250V AC 50/60Hz. Contact your local dealer or
Trigon
directly if you should need a different voltage version.
2.2
Installation Information
During unpacking, please inspect the unit for any potential transportation damage. If you
notice any damage, please get in contact with your dealer.
Confirm the contents of the box. In addition to the
SnowWhite II
, you should also
have the following:
- Floor Power Supply
- Power Cord
- User’s Manual
- Warranty Card
Place the unit on a dry, level surface. Be sure that the unit has good ventilation around it.
Strong magnetic fields commonly found in amplifier transformers and halogen light
transformers can induce hum into a system. Because of this, it is best to place the unit a
reasonable distance from such devices. Also, the audio interconnects should not be run in
parallel to AC power cables as this can also induce noise.
Hum is also produced from light bulbs. It is best to place audio equipment at least 3 feet
away from them.
Try to utilize natural light and make sure not to use the
SnowWhite II
unmonitored
next to heat sources.
4
