Trigon Electronics Miniguard 100B, Programming Manual

Page: 2 / 13

Table of Contents
Page 2
To Access Programming Mode
————————————
- Page 2
Changing Program access code
——————————
- Page 2
Operational Enable TED on/off
——————————
Page 3
Dialer mode
————————————————————————————
Page 4
New resident with phone number
————————
- Page 5
Input or Edit Resident Names
——————————
- Page 5
Basic text editing
————————————————————
- Page 6
Creating Entry Codes
——————————————————
- Page 7
Creating Card Codes
———————————————————
- Page 7
Programming system clock
——————————————
- Page 8
View the clock
———————————————————
- Page 8
Set the clock
————————————————————
- Page 8
Reset Tone Functions
——————————————————
- Page 9
Default door settings for resident
————
- Page 10
Wiring instructions
———————————————————
- Page 11
Complete Programming Overview
———————————
Page 12
*
2 4 6 8
Access Programming Mode
Push Call Button at the Unit's Front Panel. You should hear a false Dial Tone.
Or you may call the Unit and wait for the Unit's Answer Tones.
Enter the Programming Mode using key sequence: *2468.
You should hear two "ACK" tones and the panel display, if available, shows "Program Mode".
Initial key stroke for entering programming mode
Default programming code for new universal board
NOTE Enter: ## Exits Programming Mode.
Change Program Access Code
Command to set: 3nnnn Where "nnnn" is the new 4 digit programming access code.
Programming Number
New Program access Code
This command sets a 4 digit code that is used at the keypad, or remotely via touch tone,
to place this unit into programming mode. This is a very important number, for without it
you will not be able to program your unit except via Modem. To program this unit via key-
pad this code is entered as "*2468". Since all units will have this code number as the
factory default, it is strongly suggested that you change this code soon after initial in-
stallation. Anyone with the knowledge of this code can put your unit into programming mode
and erase everything with one command. Be absolutely sure to write down the new replace-
ment code or you will lock yourself out from future programming changes. If you lose this
code you may call Trigon and we can call the unit and send a special command to restore
this code to factory default of 2468.
3 2 4 6 8