Commissioning
DALI XC_IB 3.0 | 01.2014 | en
12
5
Commissioning
Requirement:
– Lighting system must have been fully installed.
A DALI XC in
Prog
operating mode is designed for commissioning a lighting system. However, if all DALI XC devices in
the lighting system are already installed and can no longer be accessed, a DALI XC in
GC
operating mode can be
used to commission the system. This procedure is useful for cases where the lighting system needs to be re-initialised.
i
Note
After commissioning, the
Mode
rotary selector switch is used to switch the DALI XC from
Prog
operating mode to another mode so that it can be operated as an input device. The device must be
accessible in the concealed box for this to take place. Alternatively, a DALI XC device can be
connected to the DALI control line at an accessible point (e.g. the distribution board) for commissioning
purposes only.
Commissioning consists of three steps:
1. Start commissioning.
If the DALI XC devices in the lighting system can be accessed, commissioning can be quickly and easily started
with a DALI XC in
Prog
operating mode.
If the DALI XC devices in the lighting system can no longer be accessed, commissioning can be started with a
DALI XC in
GC
operating mode.
2. Group luminaires.
First select the luminaire to be grouped. This luminaire is then assigned to a group using a momentary-action
switch.
3. Finish commissioning.
Summary of Contents for LuxControl DALI XC
Page 1: ...luxCONTROL DALI XC ...
