12
Model 2400 High-Pressure Filling System User Guide
Replacing the Material Reservoir
Follow the instructions below to replace the material reservoir with a new preheated reservoir.
▪
Press the Hydraulic Switch so that the piston retracts to the home position.
▪
Remove the Thumb Screws and lift off the Heater Cover.
▪
Back off the Cylinder Nuts.
▪
Remove the Reservoir by pulling it backwards and up.
▪
Position the preheated reservoir into the Reservoir Guides.
▪
Push the Reservoir into the Front Cap.
▪
Slide the End Cap forward until it rests against the Reservoir.
▪
Secure the End Cap into position by tightening the Cylinder Nuts until the Cup Washers are flat.
▪
Replace the Heater Cover and Thumb Screws.
▪
Change the Hydraulic Switch to the dispense position.
Figure 8.
Replacing the Material Reservoir
Cylinder Nuts
Reservoir Guidelines
End Cap
Front Cap
Reservoir
Cup Washer
