26
CLEANING AND CARE
Cleaning of the pyrolytic enamel oven
The principle
The walls of the oven are made of special high
temperature enamel whichis shiny in appearanceand
smooth to the touch.
During the pyrolytic cleaning, the temperature of the
oven reaches approximatively 500
°
C. The food and
grease splatters are carbonised and wiped away as
ash residue when the interior is completely cold.
Smoke is filtered out by a catalyser.
The safety
The pyrolytic cleaning is perfectly safe : a safety lock
prevents any accidental opening of the door as soon
as the temperature in the oven approaches 300
°
C.
Beyond 300
°
C, the door remains locked even if the
pyrolysis cycle is interrupted (by a power failure or
deliberately). You will not be able to open the door
again until the oven has cooled.
During the cleaning cycle, a fan operates. Ventilation
continues even after the cleaning cycle until the oven
has cooled sufficiently.
Pyrolytic cleaning can only be carried out under
the control of the programmer.
Regular maintenance
After cooking, remember to wipe off any splashes or
stains with a damp sponge.
For better visibility when cleaning the oven, set the
selector to
position.
In the event of spills on the bottom panel, soak the
panel but do not scrape it and avoid abrasive cleaning
products that risk damaging surfaces (enamel,
varnish, lacquer).
Periodic maintenance
After a cleaning cycle, wipe up the ash residue left by
the pyrolytic cleaning process. Do not hesitate to run
a cleaning cycle as often as necessary. We
recommend you to run a pyrolytic cycle once per
month. This is just an indication : the frequency
depends on the level of soiling.
Run the cleaning cycle immediately after cooking to
take advantage of the residual heat in the oven. The
cleaning process will mean the oven is unavailable for
use for approximately 2 hours 30 minutes.
How to proceed ?
1. Empty the oven of all accessories (oven shelves,
grill pan). The high temperature during the
pyrolytic cycle could damage them as well as the
cavity.
2. If necessary, remove all excess soilage which
could cause too much smoke to be absorbed by
the catalyser.
3. Close the oven door.
4. Set thefunction selector and temperaturecontrols
on the pyrolytic
position .
5. Programme the pyrolytic cleaning in semi
automatic or fully automatic operation (see
following page).
6. Once the pyrolytic cycle time is over :
Return the control knobs to their OFF positions
(temperature control on
●
and then function
selector on
0
).
The“
ovenon
”neonindicatorswitchesoff andthe
door unlocks when the temperature inside the
oven is cool enough.
Cleaning the accessories
Clean them with a warm washing up liquid solution.
Rinse and dry carefully.
All manuals and user guides at all-guides.com
