11
CAUTION:
• Do not store the juice for a long time.
• The Slowstar
®
may be used for preparing seasonings (garlic or pepper), but do not use
the Slowstar
®
for grinding grains, unless soaked for 4~8 hours. (Hard or dry grains
may result in a malfunction).
• Do not operate the Slowstar
®
with wet hands; otherwise an electric shock, short circuit,
or fire may occur.
WARNINGS:
• Do not operate the Slowstar
®
for more than 30 minutes continuously. Otherwise the
motor may become overheated and a malfunction may occur. Please re-operate the
machine after a 5 minute pause.
• Do not insert any utensils, knives, or fingers into the Slowstar
®
. Please use the Plunger
to push down the food. Placing foreign objects into the juicer may result in destruction
of parts, injury, or accident.
• Do not insert fruits with hard seeds, remove seeds from the fruits before inserting them into
the Feeding Chute; it may result in destruction or malfunctioning of the Duoblade
™
Auger,
Juicing Screen, or Auger Housing.
If the Slowstar
®
suddenly stops during use
If the Slowstar
®
stops in the middle of operation, please turn the switch to the ‘OFF’ posi-
tion first, and then turn the switch to the ‘REVERSE’ position and hold to push back the
fruits or vegetables that might have gotten stuck between the Duoblade
™
Auger and the
Auger Housing. Turn the switch to the ‘OFF’ position then to the ‘ON’ position. (Repeat this
procedures 3 times). Upon releasing the ‘REVERSE’ button, the Slowstar
®
will stop.
• While operating the Slowstar
®
in the ‘ON’ position, please turn the switch to the ‘OFF’
position and wait until the Slowstar
®
stops completely before using the ‘REVERSE’ position.
If the Slowstar
®
is switched to ‘REVERSE’ position before the Slowstar
®
stops completely,
it may cause a malfunction.
• If the Slowstar
®
still does not work, please turn the switch to the ‘OFF’ position and
unplug the Slowstar
®
. Then disassemble the parts and clean to use again.
How to use Mincer (SW-2000 Model Only)
1. Assemble the Auger Housing for Mincer with the Main Body. Rotate the housing
clockwise towards the Safety Link.
2. Place the Duoblade
™
Auger into the middle of the Mincer.
3. Assembling the Mincer Lid - Match the Mincer Lid marks with the Auger Housing for
Mincer marks, and then rotate the Mincer Lid towards the Auger Housing for Mincer
handle marks.
4. Place a container under the Outlet
5. Put ingredients into the Feeding Chute.
