![background image](http://html1.mh-extra.com/html/triax/m7txn/m7txn_manual_1160829020.webp)
19
Troubleshooting
Watch does not “link” with the USB PCdock:
Try repositioning the USB PCdock away from your monitor or
other electronic devices. You can also try moving the watch
closer to the PCdock. Turn off any devices nearby that may be
using the same radio frequency: 916MHz (cordless phones,
baby monitors, etc.). Press the mode button several times
to re-enter PC mode and try “linking” again.
USB PC Link module blue LED is not flashing:
Make sure the PCdock is plugged into the USB port
on your computer. Make sure you have installed the software
application and drivers.
HRM chest strap does not “link” with the watch:
Make sure the chest strap is on by placing it on the body.
The unit turns on when it detects the two electrodes on
the body. It is recommended to wear the chest strap directly
against the skin.
Try to reposition the HRM chest strap slightly.
Try replacing the battery.
Moisten the electrodes with water or gel to make better
contact with the body. If you are waering the chest strap over
clothing, try getting the clothing wet also.
Re-enter CHRONO or WRKOUT mode to the watch.
SDM pod does not “link” with the watch:
Make sure the unit is on by depressing the power switch on the
top of the unit. The red LED indicator should be flashing slowly.
Try replacing the battery.
Re-enter CHRONO or WRKOUT mode on the watch.
SDM Pod Attachment to shoe:
Make sure the SDM Pod is attached to the laces securely
enough that there is no “wobble” when you are running.
The Pod should be aligned with the foot and secured well
enough that the alignment does not change during a run.
Orthotics:
People who wear orthotics or have extreme pronation or
supination in their stride may experience reduced accuracy.
Try re-calibrating for improved accuracy.
Varying Paces:
People who run at varying paces within a run may
experience reduced accuracy. Try calibrating at the
speed you usually run.
LED light on SDM Pod flashes rapidly:
This indicates low battery power. Replace the AAA
battery in the SDM Pod.
Watch beeps continuously:
If you have the pace zone alarm on and your pace does not
fall within your limits, the watch will beep to let you know
you are out of your zone.
See page 8 for instructions on how
to turn off the pace zone alarm.
Crosstalk:
If you receive "crosstalk" from another electronic device,
press the button on the speed sensor. The watch and speed
sensor will begin linking on another channel.
Watch display is frozen:
The display of your watch may "freeze" due to static
electricity or recent battery replacement. If this occurs,
press and hold all four buttons at the same time.
This will erase the data in the memory and allow you
to reset the watch to the factory settings.
Press and hold all four buttons
at the same time to reset
the watch to the factory settings