Trouble-shooting
- 30 -
- 30 -30
Trouble-shooting
Every electric device can have a malfunction. It does not automatically mean that it is
defective. In most cases it happens because of a feed cable, plug-and-socket connections or
access mistakes. Please control the following items before taking the receiver to your
specialised dealer:
Problem
Possible causes
Help, Tips
Receiver can not be
turned ON
Mains adapter not connected to
mains
Check if mains adapter is
plugged in correctly.
Try another electric device at
the same power socket.
Batteries of the remote control
are not inserted / inserted faulty
Check batteries
No or bad picture
TV set is running on wrong
channel
Check set up of the TV set
Scart or HDMI cable is damaged
or plugged in incorrectly
Replace or plug in the Scart or
HDMI cable correctly
No audio
Volume is set too low
Increase volume
Cable damaged or plugged in
incorrectly
Check cable and ports
Remote control does
not work
Distance to big
Come closer to receiver, point
remote control directly towards
receiver
Batteries are exhausted or
inserted incorrectly
Insert batteries correctly
IR receiver is covered or not
reachable by the IR signal
Remove barriers between
remote control and receiver
Timer is activated
Deactivate timer
Time is displayed
wrongfully
Difference between local time
and GMT is set incorrectly.
Enter menu
Receiver setup
and
set time difference correctly
Timer is activated at the
wrong time
Difference between local time
and GMT is set incorrectly.
Enter menu
Receiver setup
and
set time difference correctly
No picture,
Channel change on
screen graphic shows
”No valid signal!”
Cable is defect or plugged in
incorrectly
Check cable and ports
Channel has changed frequency Perform channel search
Incorrect Settings in menu
„
Settings
“
Correct settings or restore the
factory default status
Technical data
- 31 -
- 31 -31
Technical data
General
6000 channels
On screen video text and VBI video text
Fast-OSD
quick channel change (zapping)
no delay at on screen graphic display
big type for better readability
concise help for all menus
EPG
Electronic Programme (EPG)
Channel list editor
copy, replace, delete
blockwise operations
Channel search
automatic channel search
identification of encrypted channels
manual channel search
Further details
Display for signal strength and quality
Separate audio output settings for SCART and Digital
SWAP function
DVB subtitling
DATA interface for updates and channel list transfer; updates
available via website
Hardware
CPU
32 bit RISC CPU
HDMI
with Upscaler
USB
USB 2.0
Video
1 × SCART with FBAS, Y/C, YUV or RGB support
16:9 signal
Audio
Audio-DAC
Optical audio out
Volume control
Reception
50,5 – 858MHz (Band I, III, IV, V)
7 or 8 MHz bandwidth switching
Handling
Remote control, rare panel control
Power requirement
+12 Volt
Standby mode: Low-Power Standby ON <1W
Low-Power Standby OFF about 4W
Batteries for remote
control
2x1.5V (size AAA)
Surrounding
temperature
+5°C to +40°C
Dimensions
B x H x T: 230 x 35 x 140 mm
Weight
Ca. 580g
Subject to change without prior notice. Errors in interpretation excepted.
