4
PRESTIGE SOLO & EXCELLENCE IGNITION KIT - INSTALLATION INSTRUCTIONS
1.5. Kit installation
1.5.1 Required tools and material
•
Wrench, Torx, 25
•
Wrench, 10 mm
1.5.2 Installation of Igniter and Spark Generator
1. Install the new igniter, with its new gasket, on the
burner mounting plate support (See
Fig. 4)
.
2. Tighten 2 igniter screws by hand, then torque
screws between 13 and 18 lbf-in.
Do not exceed the recommended max. torque
value for the igniter attachment screws to pre-
vent the igniter stems from distorting.
3. Connect the ignition wire to the spark generator (
1
). Slide
the protection sleeve (
2
) over the connector (See
Fig. 5)
.
Fig. 4 - Prestige Solo & Excellence - New igniter Installation
4. Remove the blower clamp screw (
A
). Retain for rein-
stallation. (See
Fig. 6)
.
Fig. 5 - Prestige Solo & Excellence - Ignition Wire Connection
1
2
5. Locate the spark generator with bracket (
B
) on the
blower clamp (
A
), aligning bracket hole with blow-
er clamp hole. (See
Fig. 6)
.
6. Reinstall the blower clamp screw (
A
) to secure
the spark generator bracket to the blower clamp.
Torque screw between 62 and 71 lbf-in.
7. Install the igniter cable boot so that the cable is
smooth with no sharp bends and doesn’t curl on
itself. See
Fig. 7 &
Fig. 8.
8. Connect the spark generator connector (
C
) to the
new igniter.
A
B
C
Fig. 6 - Prestige Solo & Excellence - Spark Generator Installation
Fig. 7 - Prestige Solo 155 to 399 - Igniter Kit Installed
Fig. 8 - Prestige Solo & Excellence - Igniter Cable Installation
OK
NO
1.5.3 Printed Circuit Board replacement
1. Disconnect violet wire (ionization current return)
(See
Fig. 13
) from circuit board ground connection.
Discard the wire.
2. Disconnect all wire terminals from the board.
3. Remove the circuit board and discard according to
applicable local regulations (See
Fig. 9
).
4. Install new circuit board, making sure it is secured in
the retaining clips (See
Fig. 10
).
NOTICE
