Model 550 Tube Severing Tool
92-0116 Rev. 210906
17
7. REPAIRS AND REPLACEMENT
WARNING
WARNING: Disconnect the Drive Unit from the Model 550 Tube Cutter before you do
any repairs or replacements. This will decrease the risk of personal injury or equipment
damage.
Replacement of the Cutter Wheel
1.
Rotate the drive shaft manually clockwise to rotate the cutter carriage to the desired
position.
Cutter Wheel Securing Screw
Cutter Wheel
Figure 3: Replacement of the Cutter Wheel
2. Rotate the Cutter Carriage Assy until you see the Cutting Wheel and the cutter Wheel
Securing Pin access hole. Refer to Fig. 3.
3. Take a small screwdriver and a pair of needle nose pliers to remove the Wheel
Securing Pin.
4. Insert a pair of needle nose pliers, and then take hold of the edge of the Cutter Wheel.
5. Remove the Cutter Wheel.
6. Install the new Cutter Wheel by reversing the removal procedure.