Page 6
ASSEMBLY
Machine is received fully assembled with the exception of mounting the honing disc and preparation of the disc
for sharpening as follows:
STEP 1:
Place machine on sturdy table or bench.
STEP 2: WASH HONING DISC
Wash both sides of honing disc with warm water and mild dish washing detergent (suggest Dawn Dish soap,
DO NOT use detergent for automatic dishwashers).
Scrub disc with soap solution and soft bristle brush.
Rinse in warm water.
Let disc air dry only, DO NOT dry with towel as this will leave lint or fabric on disc.
STEP 3: DISC IDENTIFICATION
Disc is double sided, and stamped in center recess for identification.
“H” side (HOLLOW GROUND) is used for small animal and human hair.
“F” side (FLAT GROUND) is used for large animal blades.
STEP 4: INSTALL HONING DISC
Remove ¼” screw from drive plate and install honing disc onto machine by placing large center hole in disc
onto spindle while aligning the threaded hole in drive plate with small hole in honing disc.
Insert ¼” screw through small hole in honing disc and tighten.
Cover large center hole in disc with a piece of adhesive (duct) tape to prevent honing powder from getting onto
spindle.
Place tape over end of spindle shaft
Attach disc to spindle with supplied screw