X-DJ 13E80 ANC
PAG.8
Headphones have an internal rechargeable battery, the first time you use headphones, make a charge
for 3-4 hours; a fully charged battery headphones have a battery life of about 10 hours of music
listening.
When the headset indicates a low battery, turn Off the headset and charge it:
- Connect the included Micro USB cable to an external device equipped with USB port (computer,
tablet...) or to a power supply with USB 5V
(not supplied);
- Connect the supplied USB cable into the Micro USB connector (6); while charging the red LED
indicator (4) will light;
- Charging is completed, the LED light will be Off‘.
Indication of battery being phased out:
- When the battery is low, you will hear the message “LOW BATTERY” a few times then the
headset will automatically turn off.
ANC (ACTIVE NOISE CONTROL): ON/OFF
The ANC circuit actually senses external noise through the built-in microphone and sends unit itself
equal and opposite cancellation signels.
- The ANC effect may not be noticeable in a very quiet environment, or you may hear little noise.
- The ANC effect may vary depending on how you put the unit or buzzing (squeaking) may occur. In this
case, remove the unit and then wear it again.
- The ANC function is mainly effective for low frequency noise. The noise can be reduced, but it can not be
completely eliminated.
- The mobile phone may cause interference and noise to the unit. If this happens, pleace the unit away from
the mobile phone.
- Do not cover the microphone of this unit with your hand, the ANC function may not function properly or
buzzing may occur (squeak).
•
Turn On: When the ANC function is Off, turn the ANC switch On (7) then the ANC indicator (4)
will be On;
•
Turn Off: When the ANC function is enabled, turn the ANC switch Off (7) then the ANC indicator
(4) will be Off.
POWER ON AND OFF
•
Turn ON: In power Off status, long press
(2)
power On button
, voice prompt “Power On”
and the Blue light flash.
•
Turn Off: In power On statur, press and hold
(2)
power Off button,
voice prompt “Power
Off” and the Red indicator (4) light will blink and then be off.
Auto Turn off
: after a period of inactivity with Bluetooth pairing inactive, the headphones automati-
cally turn off. To turn on them, the headphones must be switched on again.
PAIRING WITH A BLUETOOTH DEVICE
1. In power Off mode, press and hold the power On button
(2) for 3 seconds until the red and
blue light flash, there is voice “Ready to pair”. The headset will enter pairing mode. (If the power
ENGLISH
Summary of Contents for X-DJ 13E80 ANC
Page 2: ......
