TCSS-100/130
4669
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel/fax:+48 58 56 300 80 www.ega.com.pl
24
maintenance and cleaning work.
There is a risk of burns.
Before each use, check the equipment for obvious defects such as loose, worn or damaged
components and check that screws or other parts are sitting correctly. In particular, check
the grinding disk. Replace damaged parts.
Cleaning
Do not use cleaning agents or solvents.
Chemical substances may attack plastic parts of the equipment.
Never clean the equipment under running water.
Changing the grinding disk
Instructions for changing:
• To change the grinding disk, use the tools included in the scope of delivery.
• Never operate the equipment without the protective screen.
• Ensure that the rotation speed specified on the grinding disk is equal to or greater than the
rated speed of the equipment.
Ensure that the disk dimensions fit the equipment.
• Use only fault-free grinding disks (ring test). Change the grinding disk immediately if the
grinding disk is worn so heavily that readjustment of the protective screen is no longer
possible.
• If the locator hole in a grinding disk is too small, do not subsequently re-drill in order to
increase the size.
• Do not use separated reduction bushes or adapters in order to make a grinding disk fit
where the hole is too large.
• Do not use saw blades.
• Reassemble the equipment fully after changing the grinding disk.
Switch off the equipment and disconnect from the mains.
Allow the equipment to cool.
1. Unscrew and remove the grinding disk cover by loosening the fixing screws (4).
2. Lock the spindle using the open ended wrench (24) and use the Allen key (23) to loosen
the hex nuts (27).
3.Remove the nuts, ring washer (28), external flange (29) and grinding disk (8).
Summary of Contents for TCSS-100
Page 2: ......
