TCSS-100/130
4669
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel/fax:+48 58 56 300 80 www.ega.com.pl
22
There is a risk of injury.
Switching on and off
Ensure that the mains voltage matches the specifications on the rating plate.
Ensure that the on/off switch (Fig.A no. 1) is switched off (“0” position) when inserting the
plug into the socket.
Connect the equipment to the mains.
1. To switch on, press t
he on/off switch (“I“ position); the equipment starts up.
2.
To switch off, press the on/off switch (“0“ position); the equipment switches off.
The disk will continue to run after the equipment is switched off. There is a risk of injury.
Test run:
Before starting work and after each change of grinding disk, carry out a test run of at least
30 seconds with no load. Switch off the equipment immediately if the disk runs lumpy,
substantial vibrations occur, or abnormal noises are generated.
Sharpening the saw chain
An incorrectly sharpened saw chain may damage the chain the increase the risk of the saw
jumping back.
Ensure that the chain is aligned accurately.
Observe the correct rake angle and minimum dimensions of the saw chain. Remove as little
material as possible. Do not grind in drive or connecting links, otherwise the saw chain may
rupture. In the event of non-observance, there is a risk of accidents when handling the
chainsaw.
Instructions for sharpening
• After sharpening, all cutting links must be of equal length and width.
• The chain is worn and must be replaced with a new saw chain if only approx. 4 mm of
cutting tooth remain.
• Ensure that the protective screen on spring bearings is freely movable and does not jam.
Do not fi rmly tighten the fixing screws for the protective screen.
Insert the saw chain:
1. Loosen the fixing screw (9) and insert the saw chain into the guide rail (12). The cutting
edges must face towards the grinding disk (8).
2. Fold down the stopper (10) and pull the saw chain back until the cutting tooth (25) to be
sharpened is against the stopper (see image 1)
Summary of Contents for TCSS-100
Page 2: ......
