Revision A
6/21/2019
tres900s Operations Manual
Page
10
You can also select the
Enter range of data
box and enter
the starting ID then the ending ID. You have up to 100
different IDs. Once completed, just press the
OK
to save or
Cancel
to not save them. You now need to press the
Send
to Reader
button to update your changes into the readers
flash memory.
You can send this data to the Reader, Fetch numbers already
stored in the Reader or you can Clear and start over. Remember to always send your changes to
the memory by using the ‘
Set parameters
’ option mentioned earlier after you ‘
Close
’ from this
option. This is just a precaution; I also will query the memory to see if my changes were saved
properly.
Relay
Enabled
, when this box is selected, you enable the use of the relay.
It works off the Facility Code, if no Facility Code selected, then it
closes contact on any valid Wiegand input read. If the Facility Code
and/or ID range selected, the relay will close only when a valid tag
with that Facility Code and ID range is received from the reader.
Hold Time
, this is the relay hold time, you select between 100 mS…3 seconds. When the relay
is selected, and a valid tag is read, this time selection will keep the relay closed for that period
of time. This is handy when you want to control a device for a longer or shorter period of time
after the valid tag is read and manipulated per user configuration.
Indicators
Here is the section where you turn the LED and the Audible Beeper ON/OFF
for a valid read. The factory default is on but if you do not need to see an
LED flashing or hear the Beeper beeping for a valid Wiegand read, then you
can turn either of them off here.
Log Window
This is a very useful section, every valid tag read will be
converted and displayed here. Even if you set facility code, every
valid tag read will be displayed. This is a very useful tool for
troubleshooting your tag data and a good way to check the tags
programming.
Pause
, this icon button just stops displaying the inputted tag data.
Like anything else, if you tired of seeing data displayed, then you
pause the data being displayed.
Clear
, this icon button is useful for clearing out the log window.
Sometimes you get too much data and want to clear it out and start
over.
