MBS1000 Installation Guide
4-5
Trenton Systems, Inc.
M
EMORY
DIMM
S AND
B
ATTERY
R
EPLACEMENT
Following proper anti-static precautions mentioned earlier and referring to Figure 12, remove the
MBC8240 SBC to replace the memory DIMMs. Push down on the memory DIMM socket tab located on
opposite sides of each module. This downward action releases a memory DIMM from its socket and
pushes the module up. Remove the module and replace it with the FRU part five (8GB DDR3-1600 ECC
Memory DIMM ) as illustrated in Figure 8.
Refer to Figure 8 and locate the SBC’s battery. Again using proper anti-static precautions mentioned
earlier, slightly push the battery toward the inside of the SBC while lifting up on the battery to remove it
from its socket. Install the new batter ensuring that the + side of the board faces the outer edge of the SBC.
CAUTION:
Risk of explosion if the system host board battery is replaced by and incorrect type. Dispose
of used batteries according to the instructions.
O
PTION
C
ARD
I
NSTALLATION
Following proper anti-static precautions mentioned earlier and referring to Figure 13 below, install the
desired PCI Express option card into the riser card connected to the MBC8240 riser card slot. If the
MBC8240 does not have the riser card installed, plug it into the card slot on the SBC and secure it to the
two white plastic mounting tabs using the screw hardware provided by Trenton. Once the option card is
installed, ensure that it aligns properly with the MBC8240’s rear panel access slot.
Figure 13 – Option Card Installation
