4
Introduction
Under infrastructure mode there are 2 types of settings, Cfg ESS-ID
mode and Any ESS-ID mode where communication between
PC/Notebook and print server is through the Access Point acting as a
bridge between wired and wireless network.
Cfg ESS-ID (Configured ESS-ID)
•
Connect to Access Point with ESS-ID
•
Default ESS-ID is ‘default’
Any ESS-ID
•
Connect to Access Point with any ESS-ID close to the unit
Reset Button
Reset will be initiated when the reset button is pressed once and
the LPT1, LPT2 & LPT3 begins to flash.
Factory Reset will be initiated when the reset button is pressed for
three seconds or when the LPT1, LPT2 & LPT3 begins to light up.
Release the reset button and LPT1, LPT2 & LPT3 will begin to
flash indicating the print server is changing to factory reset. When
factory reset is completed the print server will be set to default on
channel 11 and EES-ID is set as ‘default’.
DC Power Connector
The DC power input connector is located on the Print Server’s rear
panel and is labeled DC 5V/2.4A.
