TRENDnet TEG-240WS, User Manual, Page: 10 / 27

13
IDENTIFYING EXTERNAL COMPONENTS
This chapter describes the front panel, rear panel, and LED indicators
of the Switch.
Front Panel
The figure below shows the front panels of the Switch.
Figure 4. Front panel
LED Indicators:
Comprehensive LED indicators display the status of the switch and
the network (see the LED Indicators chapter below).
1000BASE-T Gigabit Ethernet Ports (Port 1~24):
The Switch twenty-four Gigabit twisted pair ports, supported auto negotiable
10/100/1000Mbps and auto MDI/MDIX crossover detection function, this
function gives true “plug and play” capability, just need to plug-in the
network cable to the hub directly and don’t care if the end node is NIC
(Network Interface Card) or switch and hub.
These ports can operate in
half-duplex mode for 10/100Mbps and full- duplex mode for
10/100/1000Mbps.
Note: When the port is set to “Forced Mode”, the Auto MDI/MDIX
will be disabled.
14
Mini-GBIC Slots (Port 23~24)
The Switch is equipped with two combo mini-GBIC ports, supported
optional 1000BASE-SX/LX mini-GBIC module.
The 1000BASE-T port 23 and 24 are the same ports with the mini-
GBIC port 23 and 24, when plug in the mini-GBIC module, the device
will activate mini-GBIC, and the RJ45 port will be disabled.
Rear Panel
The rear panel of the Switch consists of an AC power connector and
Reset button. The following shows the rear panel of the Switch.
Figure 5. Rear panel
AC Power Connector:
This is a three-pronged connector that supports the power cord. Plug
in the female connector of the provided power cord into this
connector, and the male into a power outlet. Supported input voltages
range from 100-240V AC at 50-60Hz.
Reset:
The Reset button is to reset all the setting back to the factory default.
Note: Be sure that you recorded the setting of your device, else all
the setting will be erased when pressing the “Reset” button.