TRENDnet TE100-S4PCI, User Manual

Page: 12 / 15

8
3. Insert the contact edge of the 4-Port 10/100Mbps NWay Ethernet
Switch Card into the connector of any available PCI Bus Master
expansion slot. Press the card firmly into the connector and
ascertain that the card’s contacts are fully seated in the connector.
4. Install the bracket screw that secures the card to the computer
chassis.
5. Replace the computer’s chassis cover.
6. Reconnect the computer’s power cord, and switch computer
power on. If the BIOS section of your computer boot program
is Plug and Play compliant, then at power-up the BIOS will
automatically configure any newly installed 4-Port 10/100Mbps
NWay Ethernet Switch Card.
LED Indicators
Link/Activity (LINK/ACT): This LED indicator lights green when
there is a secure connection (or link) to a device at the port. The LED
indicators blink
green whenever there is reception or transmission of
data occurring at a port.
100Mbps Indicator (100Mbps): This LED indicator lights green
when a 100Mbps network is connected to this port. If a 10Mbps
device is connected to this port, the LED indicator is OFF.
Collision/Full-duplex (COL/FDX): This LED indicator lights green
when this port is in full duplex (FDX) mode. Otherwise, it is OFF for
half duplex (HDX) operations. It blinks
green , when collisions are
occurring on this port.