T4 - USA
-14-
3
2
1
Removing the Router from the Plunge
Base
■
Never separate the router from the base while
a bit is fitted in the collet. Always disconnect
the router from the power supply before
separating the router from the base.
■
Remove collet nut, collet and spring.
■
Use the 14mm open ended wrench (1) to
release the clamping nut (2) on the base.
Slacken the nut off until the motor unit slides
out of the base (3).
■
Refit spring, collet and collet nut.
■
To change bits the 14mm A/F wrench and
17mm A/F wrench are used because the
spindle lock will be disengage.
■
When re-fitting the motor unit, ensure that the
switch is facing the front of the router so that
it is accessible when plunge routing.
■
Ensure that the clamping nut is re-tightened
before using the router for normal plunge
cutting operations.
Carving and Grinding
Carving and grinding applications can be carried
out with the router removed from its plunge
base. When using the router in this way, only
use multi flute carving, engraving, or de-burring
rasps and burrs.
Always unplug the machine
from the power supply before
separating the router from its
plunge base.
Never use high speed router
bits for carving operations.
MANU-T4-USA v2.0 30/8/07 1:09 pm Page 14
