PTB/KWJ900
-14-
45° Angle End Cut
Insert the three location bushes into Angle
holes (A) as shown.
Locate the template on the worktop as
illustrated ensuring that bushes are touching
the worktop edge. Clamp using two quick
action clamps.
It is recommended that depth stops are used
and three or four cuts taken. Cut from left to
right. Label must be facing down.
Routing the 45° Angle End Cut
Quick action
clamp here
Postform
edge
Location bushes in
angle holes
Direction of
router travel
Cut with
laminate
down
Cut with
laminate
up
Postform edge
Postform edge
Postform edge
Postform edge
Peninsular
Peninsular End Cuts
In order to prevent break out of
the laminate, rotation of the
cutter and feed direction of the
router must always be into the
postform edge of worktop.
MANU/PTB/900 v1.1 23/11/10 09:27 Page 14
