PH/JIG/M
-3-
1 x Mini Pocket Hole Jig with long base and
columns
1 x Short base
1 x Stepped drill 9.5mm (3/8”) diameter x
150mm long HSS
1 x Depth collar for stepped drill
1 x Square drive screwdriver bit
No.2 x 150mm long
50 x Self-tapping square head screws
No.7 x 30mm
1 x Hex key 4mm A/F
1 x Hex Key 2.5mm A/F
1 x Manual
1 x Guarantee registration card
POCKET HOLE CONCEPT
A pocket hole concept involves clamping a
pocket hole jig to one piece of the material to
be joined in the jig and boring two counter-
bored holes with a special stepped drill. This
piece of material is joined to the other piece
and assembled with 30mm long self-tapping
screws, which once driven into the material
will provide a strong joint.
No pilot hole is required, but wood glue should
be used to provide a strong long lasting joint.
The screw removes the need for clamping and
the component can be handled whilst the glue
is drying.
It is ideally suited for use with 19mm (3/4”)
thick material because the distance from the
base of the jig to the drill guide, combined with
the angle of the screws, causes the screw to
exit the 19mm material at its centre.
An accessory stepped drill bit with collar
Ref. SNAP/PHD/95 is available with a 1/4”
hex quick-change fitting, which allows faster
tool change.
ITEMS REQUIRED
n
Drill with minimum 10mm chuck.
n
Hand tools.
n
Clamps.
ITEMS ENCLOSED
