22
SERVICINGN
AIRPRO MAX
Removing the respirator
Do not remove the respirator until you have vacated the contaminated area.
1.
Before taking the respirator off, loosen the quick release headband by pressing
the ratchet button (Figure 15) and simultaneously rotating the ratchet counter-
clockwise.
2.
Pull the face seal away from the chin to allow easy removal of the respirator.
3.
Remove the respirator. Press the on/off switch to switch the respirator off.
4.
If special decontamination procedures are required, take appropriate precautions
and place the respirator in a suitable sealed container.
5.
Otherwise clean the respirator as indicated on page 22 after every use.
SERVICING
Cleaning
Remove respirator from
user’s
head before cleaning.
WARNING
:
Never use pressurised air on any part of the respirator.
•
Before cleaning remove face seal, brow pad, brow seal, crown pad, nape pad,
nape spacer, HEPA filter with cover along with the rechargeable battery. Insert
provided cleaning plugs as shown at Figure 19
–
Figure 21.
•
Do not turn the respirator upside down and fill any area or cavity with liquids.
•
For respirators with contamination, ensure that the face shield is down and
respirator is upright. Clean using a clean cloth with a mild solution of a household
liquid soap and water. For ingrained dirt on the outside of the respirator
(excluding visor), a nailbrush or ultrasonic brush may be used. Dry the respirator
with a clean lint free cloth - do not use a heat source.
•
Wipe the inside & outside of the respirator.
PUREWIPE
cleaning wipes are
recommended for this purpose.
•
Do not immerse the respirator in water or any fluid.
•
Do not use organic solvents or abrasive cleaning agents on any part of the
respirator.
•
Disposal and cleaning of parts should be undertaken in accordance with local
health and safety, and environmental regulations.
•
If the respirator has been used in an area that has caused it to become
contaminated with a substance requiring special decontamination procedures,
observe the precautions described in the manufacturer's health and safety
information.
NOTE
: For further advice and support on fitting and cleaning procedures please
contact Customer Services.
