N-Platform Hardware Installation and Safety Guide
43
Figure 8. TippingPoint 660N - back panel
1.
Power Supplies
2.
Power Supply Reset Button
3.
Power Cord Bracket
4.
Ground Strap Mounting
Follow the procedures in this section to install and use the power cord retention bracket and the cable
management bracket.
Installing the bracket
Describes how to install the bracket.
Use the following procedure to install the power cord retention bracket:
1.
Orient the bracket against the back surface of the chassis.
2.
Slide the bracket over the two shoulder rivets on the back of the chassis.
The spring-loaded plunger in the center of the bracket slides into place.
Using the power cord retention bracket
Describes how to attach the power cord to the retention bracket.
Follow this procedure to attach the power cord to the retention bracket:
1.
Fold the power cable and slide it into the slot.