23
TREK SERVICE INFORMATION August 2016
Figure 9.4. Seat tube grommet on cable liner to front
derailleur
Figure 9.5. Rear derailleur cable passing through the
dropout housing stop
Figure 9.3. Correct orientation of seat tube grommet
Drive side
To Install The Front Derailleur
1.
Install the front derailleur with the special spherical washer (Figure 9.2) and tighten to
the manufacturer’s specifications.
Note: The 2014 Speed Concept frame uses an integrated carbon fiber front hanger. This
hanger requires a special spherical washer to allow you to adjust the position of the
derailleur. Do not use the washer from the derailleur manufacturer. The Speed Concept
spherical washer, which is identical to the one used on the 2013 Madone, is PN 319576
.
2. Orient the seat tube grommet (Figure 9.3) and then snap the grommet into the frame
hole in the seat tube (Figure 9.4).
Figure 9.2. Spherical washer for carbon hanger (required)
3. Attach the cable to the derailleur and adjust as normal.
To Install The Rear Derailleur
1.
From the bottom bracket cable guide, run the rear derailleur cable through the
chainstay and out the exit hole at the dropout.
2. Install the dropout housing stop in the dropout exit hole (Figure 9.5).
3. Measure and cut the rear derailleur housing. Install ferrules on both ends.
4. Install the housing, connect the cable to the derailleur, and adjust the derailleur as
normal.
