Instructions for Use and Maintenance 120H-HY – 190H-HY (0901)
4.2 Maintenance
schedule
Position Interv
al
Type Number
Note
All screws and bolts
8 h
Check
The whole
equipment
Check that all screws and bolts are
properly tightened and not loose.
Wearing edge
Daily
Check
1 pcs
Check the wearing edge for wear.
Turn over or replace as needed.
Cross shaft
40 h
Grease
1 pcs
NLGI2 EP
Shear bolt clutch
40 h
Grease
2 pcs
NLGI2 EP
Feeding auger
40 h
Grease
2pcs/
auger
NLGI2 EP
Transmission chain,
feeding auger
40 h
Oil
1 pcs
Engine oil 10W40
Transmission chain,
for gear box operation
40 h
Oil
1 pcs
Engine oil 10W40
Turntable gear
40 h
Grease
2 pcs
NLGI2 EP
Chain tensioner
40 h
Adjust-
ment
1 pcs
Check the tension. You should be
able to push the chain down about
7mm (9/32”) The feeder screw
should run smoothly without any
noise from the chain.
Gearbox
40 h
Check
1 pcs
Visually check of the oil level, fill if
needed.
Oil SAE 80W/90 API GL4/GL5,
Industrial gear oil ISO VG 220
Gearbox
First
50 h
Oil change
Oil SAE 80W/90 API GL4/GL5,
ISO VG 220
Gearbox
500h/
yearly
Oil change
Oil SAE 80W/90 API GL4/GL5,
ISO VG 220
When lubricating use low temperature grease. These intervals are to be used for normal
usage. Always lubricate after cleaning with water.
trejonindustries.se
22
