Tregaskiss Motoman XRC EA1400, Addendum

Page: 18 / 20

STEP #9: Install Consumables to the Gooseneck
IMPORTANT

Be sure all parts are tightened well before welding to prevent overheating of contact tip.

Torque specs - Retaining Head 80 in.-lbs. / Contact Tip 30 in.-lbs.

When installing the retaining head make sure it is tightened with a 5/8” (16 mm) wrench.

To prevent scoring on retaining head do not use pliers.
Removal and Replacement

Pull slip-on nozzles off with a clockwise twisting motion.

When installing nozzle, exposed insulator should nest inside TOUGH GUN I.C.E.
™ insulator to assure
concentricity.

Replace retaining head with large bore toward the gooseneck. Tighten until retainer is secure.

External gooseneck thread can be cleaned with a 9/16” - 18 die.
STEP #10: Replace the Cover on the Robot

Reverse the instructions from step #5 and re-install the cover to the robot
MAINTENANCE/SPARE PARTS/PARTS BREAKDOWN

Refer to the following Tech Guide for this information:
o
Low-Stress Robotic (LSR) System for MOTOMAN EA1400N, EA 1900N and SSA2000 Robots.
o
Part Number: M058.
RETAINING HEAD NOZZLE TOUGH LOCK
™
CONTACT TIP
GOOSENECK
Figure 13
– To complete the installation, return
the cover that was removed in STEP #5.
Figure 12
– Install the consumables to the gooseneck using the instructions listed below.
M066-1.0
17