3.
Please ensure the ice cube maker is placed on a stable table or platform to avoid malfunction.
4.
The incline angle of the ice cube maker cabinet should not exceed 45° during transportation or use.
Do not turn the ice cube maker upside down otherwise it could cause the compressor or refrigerating
system to operate incorrectly. Please allow time for the fluids in the compressor to settle after the ice
cube maker is moved or transported. Before using the ice cube maker for the first time, please wait
for 2 hours after the unit has been moved and positioned in the proper place.
5.
The ice cube maker must be placed on a dry and flat surface with sufficient ventilation, far from heat
sources such as ovens, heaters and corrosive gases. Leave about 15cm space on all sides of the ice
cube maker for proper ventilation.
6.
Do not fill the water reservoir with hot water. This may damage the ice cube maker. It is best to fill the
water reservoir with water of room temperature or lower.
7.
Do not use the appliance at a very cold environment (lower than 5
℃
).
8.
Clean the appliance by following the operation of
“CLEANING AND MAINTENANCE”
before operate.
USING YOUR ICE CUBE MAKER
1.
Ensure that the drain plug at the bottom of the water reservoir is closed well.
2.
Plug the ice cube maker into the wall outlet, the “ICE” indicator blinks.
NOTE
: please make the ice cube maker be rested for 30 minutes before plugged if it has been moved.
3.
Open the top lid and remove the ice basket.
4.
Fill the water reservoir with drinking water.
NOTE
: do not fill above the MAX water level mark.
5.
Replace the ice basket and close the top lid.
6.
Press the “ON/OFF” key, and the “ICE”
-indicator lights solidly.
7.
The ice-making cycle will last approximately 7-15 minutes, depending on the ambient temperature
and water temperature.
8.
The ice-making cycle starts with water being pumped into the ice tray situated below the evaporator.
Over the next 7-15 minutes ice forms on the evaporator. Once this has completed, the ice tray will tilt
