Traxxas Villain 1506, Owner'S Manual

Page: 13 / 24

13
The Traxxas TQ Radio System
TQ Radio System Controls
Other TQ Radio System Adjustments
In addition to the electronic throttle and steering trim controls,
your radio system features throttle neutral adjustment and
servo reversing switches.
Throttle Neutral
Adjustment
The throttle neutral
adjustment is located on the
transmitter face and controls
the forward/reverse travel of
the throttle trigger. Change
the adjustment by pressing
the button and sliding it to the desired position. There are two
settings available:
50/50: Allows equal travel for both acceleration and reverse.
70/30: Allows more throttle travel (70%) and less reverse travel
(30%). 70/30 is the recommended setting for the Villain.
Note: If you change throttle travel, you will need to reprogram
the electronic speed control.
Electronic Throttle Trim
The electronic throttle trim located on the face of the
transmitter adjusts the neutral (center) point of the throttle
servo when the servo is at rest. Your Villain uses an electronic
speed control instead of a throttle servo. This control has been
preset for you at the factory. If the adjustment is changed, the
speed control will need to be reprogrammed (see page 16).
Electronic Steering Trim
The electronic steering trim located on the face of the
transmitter adjusts the neutral (center) point of the steering
servo when the servo is at rest. Adjust this control to make the
model drive straight with no steering input at the wheel.
Servo Reversing Switches
The servo reversing switches are located on the front of the
transmitter, next to the on/off switch. Moving a switch reverses
the direction of the corresponding servo.
Each switch corresponds to a channel, as shown below. For
example, if you turn the steering wheel to the right and your
outdrives turn left, you would move the channel 1 switch to
correct the servo direction. It may be necessary to adjust the
corresponding trim control after moving a switch.
▼
▼
CH.2
CH.1
Servo Channel
Steering 1
Throttle
2
Default Setting