The Traxxas TQ-3 Radio System
17
TQ-3 Radio System Adjustments
In addition to the electronic throttle and steering trim controls,
your radio system features throttle neutral adjustment and
servo reversing switches.
Throttle Neutral Adjustment
The throttle neutral adjustment is located on the transmitter
face and controls the forward/brake travel of the throttle
trigger. Change the adjustment by pressing the button and
sliding it to the desired position. There are two settings
available:
50/50: Allows equal travel for both acceleration and braking.
70/30: Allows more throttle travel (70%) and less
brake travel (30%).
50/50 is the recommended setting for the E-Maxx.
Electronic Throttle Trim
The electronic throttle trim located on the face of the
transmitter adjusts the neutral (center) point of the throttle
trigger signal to the electronic speed control. This control has
been preset for you at the factory. If the motors run when the
truck (EVX) is switched on, then turn the throttle trim control on
the transmitter until the wheels stop. If anything more than a
slight adjustment of the throttle trim control is required, then
you should readjust your speed control. Refer to the
Adjustments section on pages 25 and 26.
Electronic Steering Trim
The electronic steering trim located on the face of the
transmitter adjusts the neutral (center) point of the steering
servo when the servo is at rest. Adjust this control to make the
model drive straight with no steering input at the wheel.
Servo Reversing Switches
On the front of the transmitter there are three switches, one for
throttle, one for steering, and one for shifting. Moving the
switches reverses the direction of the servo. For example, if you
turn your steering wheel right and the model moves left, then
switch the steering servo reversing switch to correct the servo
direction. The electronic trim may need readjustment after
moving the switches.
▼▼
CH.3
CH.2
CH.1
Channel Servo
1
Steering
2
Throttle
3
Shifting