4 0
Optional Equipment
(for qualified installers only)
© Travis Industries
4041213
1 0 0 - 0 1 1 5 2
4
Follow the directions below to remove the natural gas orifice. Apply thread sealant to the LP orifice
(.0625 dia. - it has ".0625" stamped on it) and tighten in place with a 1/2" open end wrench. Replace
the spring. Slide the adjustable shutter back in place.
1/2" Wrench
Use a 1/2” open end wrench to
unscrew the burner orifice.
NOTE:
Screw the LP orifice in
so the orifice shoulder
protrudes 5/16”
(indicating full insertion).
37
.0625
The new LP orifice
has “.0625”
stamped on it.
The old NG
orifice has “37”
stamped on it.
Apply thread
sealant to the
new orifice and
install.
5/16”
5
Replace the burner pan and ember shelf.
6
Remove the pilot orifice following the instructions below. Replace with the propane pilot orifice.
Lift the pilot hood
off the pilot
assembly.
5/32" Hex
Use a hex wrench to
unscrew the orifice.
Remove the orifice and replace with the LP orifice. Screw the
orifice all the way in and replace the pilot hood.
LP (Propane) Orifice
Orifice Identification:
NG (Natural Gas) Orifice
35
62
35
a
b
c
NOTE: when re-attaching,
this pin lines up with the
notch in the pilot hood.
7
Replace the pilot assembly (follow the instructions in step 6 in reverse order). Make sure the pilot
assembly gasket is placed correctly.
8
Install the logs and embers. Replace the glass.
