6
Operation
© Travis Industries
4090202
100-01213_000
Before You Begin
Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage,
bodily injury, or even death.
Remote Control
The remote control controls all of the functions on the fireplace. It can be placed inside the
holder and hung on the wall or it can be placed near the fireplace.
Fn
Set
Mode
Setting Up the Remote (Time, Day, Swing,
°
F/
°
C)
The remote will need to be set up when first started or when the batteries were removed or
replaced. Follow the directions below to set the time, day, and other settings.
A. Press and hold the “Set” and “Up” arrow buttons for 5 seconds.
B. The “ROOM” temperature will blink. Use the arrow keys until
°
F (fahrenheit) or
°
C (celcius) is
displayed. Press the “Set” button to set the temperature scale.
C. The “SWING” number will blink. Use the arrow keys to select the desired swing amount (1, 2
or 3
°
F, 1 or 2
°
C). The swing number determines the amount of degrees the thermostat will
wait until turning on. The larger the number, the less often the thermostat will turn on and
off. The smaller the number, the more often the thermostat will turn on and off.
D. The day of the week will blink. Use the arrow keys to select the correct day. Press the “Set”
button to set the day.
E. The hour of the day will blink. Use the arrow keys to select the correct hour. Press the “Set”
button to set the hour.
F. The minute of the hour will blink. Use the arrow keys to select the correct minute. Press the
“Set” button to set the minute.
G. The AM / PM designation will blink. Use the arrow keys to select the correct setting. Press
the “Set” button to set AM / PM.
