20
Maintenance
© Travis Industries
4090202
100-01213_000
Accent Light Bulb Replacement
W A R N I N G
: Use only 35 Watt 120 Volt T4 Halogen Bulbs (G6.35 Base)
Two accent lights are included in your fireplace to provide additional lighting. To replace, follow the directions below:
1
Shut off gas and electricity to the fireplace and let it cool for 15 minutes.
2
Remove the glass (see page 15) and logs (see page 16).
3
Remove the four corner screws holding the accent light assembly to the firebox ceiling. Do not remove the inner
screws, these hold the cover plate to the assembly. Carefully remove the assembly and place it upside down on
the firebox floor.
4
With the resting on top of the burner, remove the four screws holding the accent light cover plate to the
accent light assembly. Remove the cover plate, gasket and glass from the assembly.
5
The halogen bulb is now accessible inside the accent light assembly. Replace the halogen bulb with a 35
watt 120 volt T4 halogen bulb (G6.35 base).
N O T E
: .Take care to not touch the bulb with your fingers – use
foam packing or paper towel to hold the bulb. With the bulb replaced, the assembly may be replaced inside the
fireplace. Make sure the gasket above and below the glass are properly located. Replace the assembly into the
firebox ceiling, making sure the electrical cord is fully inserted into the cavity above the accent light.