20
Installation
(for qualified installers only)
© Travis Industries
4100519
100-01197_001
Remote Synchronization
The fireplace is shipped with the remote and fireplace
pre-synchronized
. Do not
synchronize the remote unless you are 100% sure it does not work correctly.
Synchronizing the Remote
NOTE
: The fireplace must have power and the transmitter must have batteries to complete this process.
WARNING
: Shut the gas off to the fireplace prior to conducting this process.
1
Press the “Learn” button once. The fireplace will beep once.
2
Press the “Mode” button on the remote. The fireplace will beep five times to indicate
synchronization.
NOTE: Re-setting the Receiver Module
If the receiver module fails to synchronize with the remote after two attempts, you should re-set the
receiver module. To do this, hold down the LEARN button for approximately 10 seconds until the
receiver beeps 3 times. This indicates the receiver has been re-set and can be synchronized using
the instructions above.
