24
Finalizing the Installation
© Travis Industries
4140813
100-01297
Steps for Finalizing the Installation
1. Remove the glass (see page 22).
NOTE:
If using propane (LP) convert the appliance prior to installing the media.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be
detected once it enters the firebox, ensuring gas does not build up.
3. Install the four AA batteries (included in the owner’s pack) into battery holder (see the illustration
below). The AA batteries act as a power backup in case the household (AC) power goes out and are
required for operation. Install the 9v battery (included in the owner’s pack) into control panel light
assembly (see the illustration below). The battery holder is held in place with Velcro and may be
removed for easier access.
4. Install the media (and firebacks, if applicable).
5. Replace the glass.
6. Start the heater.
7. Leak test all gas joints.
Swing the access door and
control cover down to access
the controls on the insert.
AA Battery
AA Battery
AA
Battery
Holder
AA Battery Tray
AA Battery
AA Battery
Battery for Control
Panel Lights
9v
Battery
