Traub TNL12.2, Operating Instructions Manual

Page: 55 / 62

55
Transport, installation, commissioning
TNL12.2
DTE070EN - 15.09.2021
Commissioning
Switching on the machine
Before switching on the machine, the key switch must be in the
“Production mode” position to prevent unexpected start-up or
unexpected movement.
Before initial commissioning, the machine owner is required to
check the safe condition of the machine, including its safety devic-
es. This must also be done during operation at reasonable regular
intervals, but at least after each repair and maintenance.
• Turn on from the main switch on the control cabinet.
• Switch on the NC controller from the machine operating panel.
• Press the Reset key
(any internally pending error messages are deleted).
• Open and close the work area door.
The functionality of the door switches must be checked by open-
ing and closing the work area door. Only if the safety devices
respond, the machine can be started.
Lock the work area door by pressing the GUARD key.
(The work area door must be manually locked and unlocked when setting up
the machine.
In automatic mode, the work area door can be locked with the GUARD or
AUTOMATIC START key.
LED status
on The work area door is locked
off The work area door is unlocked
flashes
The safety switch is blocked, or a secured cover/protective door
is not closed.
• Switch on the drives.
0
I
NC I
RESET
GUARD
Example shown