Tie the Cuff
Select the User ID
1
.When the blood pressure monitor is off, press and hold the MEM button
until the user ID blinks. Then press “M” button to change the user ID
between user 1 and user 2. Press “S” button to confirm your selection.
Before you start the measurement, please select the desired user ID first.
2
. After confirming the user ID, the LCD will turn off. Then you can start
your measurement now.
1
.Remove all accessories (watch, bracelet, etc) from your wrist. If your
physician has diagnosed you with poor circulation in your wrist, use the
other one.
2
.Roll or push up your sleeve to expose the skin.
3
.Apply the cuff to your wrist with your palm facing up.
4
.
Position the edge of the cuff about 1-1.5cm.
5
.
Fasten the wrist cuff around your wrist, leaving no extra room between the cuff
and your skin. If the cuff is too loose, the measurement will not be accurate.
Rest for 5 minutes before measuring.
Wait at least 3 minutes between measurements. This allows your blood
circulation to recover.
For a meaningful comparison, try to measure under similar conditions. For
example, take daily measurements at approximately the same time, on the same
wrist, or as directed by a physician.
Sit comfortably with your tested wrist resting on a flat surface.
Patients with Hypertension:
The middle of the cuff should be at the level of the right atrium of the heart;
Before starting measurement, please sit comfortably with legs uncrossed,
feet flat on the floor, back and wrist supported.
6
.
7
.
The patient must relax as much as possible and do not talk during the
measurement procedure.
13
12
MEASUREMENT
MEASUREMENT
