P a g e
|
14
Initial Status
After powering on the device
，
it will take a few seconds to initialize the system It shows as
below:
•
DVB-C
: to indicate the modulation standard of this device.
•
A/B/C/D
: to indicate the 4 carrier outputs
•
XXX.XX MHz
: to indicate the current output frequency (Range: 30~999MHz) of
the 4 carriers output, which shows in turn.
•
X.XX Mbps
: to indicate the encoding bit rate of each encoding board
respectively.
3.2
GENERAL SETTINGS FOR MAIN MENU
By pressing
“Lock” key on the front panel, user can enter the main menu. The LCD will display
the following pages:
User can press UP/DOWN buttons to specify menu item, and then press ENTER to enter the
submenus as below:
1) Status
Start up
…
Start OK
…
DVB-C A XXX.00MHz
P1 X.XXMbps P2 X.XXMbps
1 Status
2 Input Sets
3 Modulator
4 TS Config
5 Network
6 System
