Transition Networks
TN-USB-FX-01 User Guide
33589 Rev. D
Page 17 of 25
Driver Configurable Parameters
This section describes the driver's configurable parameters. See the
site for more
information on other drivers.
1. Speed & Duplex
: Sets the Ethernet link speed /duplex mode.
You must force the device to 100 Mbps
Full Duplex. See below for details.
2. NetworkAddress
: lets you set a MAC address of the device or use the device default address.
3. FlowControl
: Configure flow control advertised capabilities
(does not apply; Auto-negotiation option
not supported).
4. WakeOnLinkChange
: Wake up the computer when device detects Ethernet link Changed
-Disabled Disable WakeOnLinkChange function
-Enabled Enable WakeOnLinkChange function
5. Packet Priority & VLAN
: Enable or disable the ability to insert the 802.1Q priority and VLAN tags into
the transmit packets.
-Packet Priority & VLAN Disabled Disable to insert the 802.1Q priority and VLAN tag
-Packet Priority Enabled Only enable to insert the 802.1Q priority tag
-VLAN Enabled Only enable to insert the 802.1Q VLAN tag
-Packet Priority & VLAN Enabled Enable to insert the 802.1Q priority and VLAN tag
6. VLAN ID
: If user set a valid VLAN ID, the driver inserts the VLAN tag with this VLAN ID into the
transmit packets and device will filter the received packets.
7. WakeOnMagicPacket
: Wake up the computer when device receives a Magic Packet
(option not
supported).
8. WakeOnPattern
: Wake up the computer when device receives a packet that matches a specified
pattern
(option not supported).
9. SelectiveSuspend
: Allows NDIS to suspend an idle AX88772B network adapter by transitioning the
adapter to a low-power state
-Disabled Disable SelectiveSuspend function
-Enabled Enable SelectiveSuspend function
10. SSIdleTimeout
: Selective suspend idle time-out in units of seconds
11. TCPChecksumOffloadV4
: Enable or disable the device to calculate the TCP checksum of the transmit
IPv4 packets and check the TCP checksum of the received IPv4 packets.
-Disabled Disable the TCP Checksum Offload
-TxEnabled Enable the TCP Checksum Offload for transmit packets
-RxEnabled Enable the TCP Checksum Offload for received packets
-RxTxEnabled Enable the TCP Checksum Offload for transmit and received packets
12. UDPChecksumOffloadV4
: Enable or disable the device to calculate the UDP checksum of the
transmit IPv4 packets and check the UDP checksum of the received IPv4 packets.
-Disabled Disable the UDP Checksum Offload
-TxEnabled Enable the UDP Checksum Offload for transmit packets
-RxEnabled Enable the UDP Checksum Offload for received packets
-RxTxEnabled Enable the UDP Checksum Offload for transmit and received packets
