8
SPSVT26xx-10x
24-hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
Installation
— Continued
Install the Fiber Cable
1.
Locate or build fiber optic cable with male, two-stranded TX to RX connectors
installed at both ends.
2.
Connect the fiber cables to the SPSVT26xx-10x Device as described:
•
Connect the male TX cable connector to the female TX port.
•
Connect the male RX cable connector to the female RX port.
3.
Connect the fiber cables to the other device
(another Device, hub, etc.)
as
described:
•
Connect the male TX cable connector to the female RX port.
•
Connect the male RX cable connector to the female TX port.
Install the Copper Cable
1.
Connect the high-speed serial cable to the Device by connecting the cable’s
copper connector to the Device’s copper port.
2.
Ensure that the cable screwlocks are tightened securely. Failure to observe this
caution could cause data transfer to fail.
3.
Connect the other end of the high-speed serial cable to the other network
device
(cable router, CSU, etc.).
RX
TX
TX
RX
Device
Device
[email protected] -- Click the “Transition Now” link for a live Web chat.
9
Installation
— Continued
Power the Device
AC
1.
Install the power adapter cord to the back of the Device.
2.
Connect the power adapter plug to AC power.
3.
Verify that the Device is powered by observing the illuminated LED power
indicator light.
DC
Consult the user’s guide for the Transition Networks SPS2460-xx DC external
power supply for powering the Device.
Operation
Status LEDs
Use the status LEDs to monitor the SPSVT26xx-10x Device operation in the
network.
PWR
(on)
The Device is connected to external power.
FL
(on)
The fiber link is up.
(flashing)
The fiber link is in loop-back mode.
CL
(on)
The copper link is up.
(flashing)
The copper link is in loop-back mode.
(In asynchronous mode, the CL LED may flash if the data rates fall below
300 cycles per second.)
Copper
Fiber
RX
TX
NO
RM
LO
O
P
CL
FL
PWR
