Transition Networks SM12DP2XA Quick Start Manual Download Page 2

Page: 2 / 2

Transition Networks

SM12DP2XA Quick Start Guide

33750 Rev. D

https://www.transition.com

Page

RST (Reset) Button

: press and hold for 2-7 seconds to reset or 7-12 seconds to restore to factory defaults:

Task

Press RST button for

SYS LED Behavior

Port Status LED Behavior

Reset the Switch

2 ~ 7 seconds

Blinking Green

All LEDs OFF

Restore to Defaults

7 ~ 12 seconds

Blinking Green

All LEDs stay ON

Mounting

: Mount the switch in a standard 19-inch equipment rack, on a desktop, or shelf; see the

Install Guide

Cabling

: Make sure that the cables are suitable for your operating environment. For fiber optic connections, use

50/125 or 62.5/125 micron multimode fiber or 9/125 micron single-mode fiber. For copper connections, use UTP
for RJ-45 connections. For 1G bps connections use Category 5, 5e, 6, or 6a.

Connecting to Power

: The SM12DP2XA front panel has two power inputs for power

redundancy; the switch has a 100~240 VAC power socket for AC power Input and a
24-48 VDC power input via the terminal block. Using both Power Supplies provides
power failover when power supplies are connected to different circuits to. With fiber
and copper cabling completed, and AC and/or DC power applied, the port LEDs light,
the

SYS

LED flashes, the AC and/or DC LEDs light and the

SYS

LED goes from flashing

to steadily lit. See the

Install Guide

for Connecting to an AC and/or DC Power source.

Initial Switch Configuration

: Initial switch configuration can be via CLI or web browser. The factory defaults are

IP Address:

192.168.1.77

, User Name:

admin

, and Password:

admin

CLI Configuration

: The command-line interface (CLI) is a text-based interface

that you can access the CLI through either a direct serial connection to the
device or a Telnet session. An RJ-45 cable is used for connecting a terminal or
terminal emulator to the SM12DP2XA RJ-45 port to access the CLI. Attach the
RJ-45 serial port on the switch front panel to the cable for Telnet/CLI
configuration. Attach the other end of the DB-9 cable to a PC running Telnet.
See the

CLI Reference

for initial switch configuration via CLI.

Web UI Configuration

: The left-hand menu contains two main tabs (Switch and

DMS) each with several sub-

tabs for configuring and monitoring the switch’s

major functions. The major Switch tab functions include System, Ports, DHCP,
Security, VLAN, QoS, Diagnostics, and Maintenance. The DMS (Device
Management System) functions are DMS Mode, Graphical Monitoring,
Management, and Maintenance. See the

Web User Guide

for initial switch

configuration via web browser.

Related Information

: Related manuals include the

SM12DP2XA Install Guide

33751,

Web User Guide

33752, and

CLI Reference

33753. For Drivers, Firmware, etc. go to the

Product Support