3.
To disengage cover from chassis, slide PowerStar™ V cover
approximately one-inch toward back of the PowerStar™ V.
4.
Carefully lift PowerStar™ V cover and remove.
5.
Using needle nose pliers with insulated handle and referring to
reference diagram on the previous page, move jumpers as required
to change factory default active pin settings to active pin settings for
the site.
6.
Replace PowerStar™ V cover on chassis, sliding cover forward to
engage cover against chassis.
7.
Replace retained cover screws.
Power the PowerStar™ V
NOTE: Fuse must be installed at correct setting for power source voltage
before connecting to AC outlet.
To power ON the PowerStar™ V:
1.
At PowerStar™ V back, locate the power receptacle and associated
fuse.
2.
Verify that fuse is installed at correct rating setting for power source
voltage. (The installed fuse rating is indicated by the reading at
lower right corner of fuse holder.)
If not installed at correct setting for power source voltage:
•
Carefully open fuse receptacle, using a small flat blade
screwdriver.
•
Rotate fuse holder 180° to the correct rating orientation.
•
Install fuse holder in correct rating orientation.
•
Close fuse receptacle.
3.
Plug unit end (female) of power cord into PowerStar
™
V power
receptacle.
4.
Plug outlet end (male) of power cord into correct voltage AC wall
socket.
5.
At PowerStar™ V front, verify that POWER LED is illuminated.
110-120
110-120
220-240
220-240
Fuse Holder
Fuse Holder
110-120 Orientation
220-240 Orientation
