INSTALLATION
(continued)
Install Cable
(continued)
FIBER
1.
Locate or build 10BASE-FL compliant fiber cable with male two-
stranded TX to RX connectors at both ends.
2.
Connect male TX and RX cable connectors at one end of cable to
TX and RX female connectors, respectively, on media converter
port.
3.
Connect male TX and RX cable connectors at other end of cable to
RX and TX connectors, respectively, on 802.3 compliant fiber
device.
Connect to Power
NOTE: When the multi-port media converter is connected to an AC outlet
supplying 100-240VAC at 50-60 Hz, the hub automatically powers ON
To power ON the multi-port media converter:
1.
At multi-port media converter back, locate male power receptacle.
2.
Plug female media converter end of power cord into multi-port
media converter power receptacle.
3.
Plug male outlet end of power cord into correct voltage, properly
grounded, AC rack or wall power source.
4.
Verify that multi-port media converter is powered by observing
illuminated power and status LED(s).
OPERATION
Use the status LEDs to monitor multi-port media converter operation in the
network.
NOTE: Each 10BASE-T/10BASE-FL media converter port is identified by a
number located just above the fiber connector(s) for that 10BASE-T /10BASE-
FL port connection. The LEDs that apply to each 10BASE-T or 10BASE-FL
port connector(s) are located, when facing the multi-port media converter, at
the left of the connector(s) for that 10BASE-T or 10BASE-FL port connection.
T(wisted) P(air) LINK
Steady LED indicates good link on
10BASE-T
copper.
F(i)B(e)R LINK
Steady LED indicates good link on
10BASE-FL
fiber.
ACT(ivity)
Steady
LED indicates 10BASE-T
OR
10BASE-FL
activity.
Dark
LED indicates
NO
10BASE-T
or
10BASE-FL
activity.
POWER
Steady LED indicates connection to external
AC power.
1
2
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
ACT
FBR LINK
TP LINK
OWER
1 2
SWITCH
TX
RX
TX
RX
