4
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
CSDTF30xx-11x
Install the Slide-in-Module
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when installing the CSDTF30xx-11x slide-in-module Device. Failure
to observe this caution could result in damage to, and subsequent failure of, the
Device.
1.
Locate an emply installation slot in the PointSystem™ chassis
2.
Carefully slide the slide-in-module into the installation slot, aligning the
module with the installation guides.
3.
Ensure that the module is firmly seated inside the chassis.
4.
Push in and rotate the panel fastener screw clockwise to secure the module to
the chassis front.
Media Converter
Point System Chassis
Panel Fastener
Slot
Installation
-- Continued
Set the Loop-Back Switch
Hardware Mode:
The loop-back switch is located on the front panel of the Device and is used for
installation and network debugging procedures.
To set the switch, use a small flat-blade screwdriver or a similar device
(see the
drawing to the right).
CL
(
Coax loop-back)
Enable loop-back on the local coax interface.
--
(Center position)
Normal operation.
FL
(Fiber loop-back)
Enable loop-back on the
local fiber interface.
Software Mode:
If both Devices are under software control, the network administrator can initiate
the loop-back test function on the coax interface
(local or remote)
or on the fiber
interface
(local or remote)
.
CL
FL
[email protected] -- Click the “Transition Now” link for a live Web chat.
5
Installation
-- Continued
Install the Copper Cable
1.
Locate or build coax cables with female connectors installed at both ends.
2.
Connect the coax cables to the Device as described:
•
Connect the female TX cable connector to the male TX port.
•
Connect the female RX cable connector to the male RX port.
3.
Connect the coax cables to the other device
(switch, workstation, etc.)
as
described:
•
Connect the female TX cable connector to the male RX port.
•
Connect the female RX cable connector to the male TX port.
Install the Fiber Cable
1.
Locate or build fiber cable with male, two-stranded TX to RX connectors
installed at both ends.
2.
Connect the fiber cables to the local Device as described:
•
Connect the male TX cable connector to the female TX port.
•
Connect the male RX cable connector to the female RX port.
3.
Connect the fiber cables to the remote Device as described:
•
Connect the male TX cable connector to the female RX port.
•
Connect the male RX cable connector to the female TX port.
Connect fiber cable
to media converter
as shown.
Connect fiber cable
to other device
(media converter,
hub, etc.)
as shown
RX
TX
RX
TX
Connect coax
cable to device
as shown
Connect coax
cable to other
device as shown
RX
TX
RX
TX
