FAULT ISOLATION and CORRECTION
If the media converter fails, isolate and correct the failure by determining the
answers to the following questions and then taking the indicated action:
1.
Is the P(o)W(e)R LED on the media converter illuminated?
NO
•
Is the media converter inserted properly into the chassis?
•
Is the power cord properly installed in the chassis and at the
external power source?
•
Does the external power source provide power?
•
Contact Technical Support: (800) 260-1312.
YES
•
Proceed to step 2.
2.
Is the SDF (Signal Detect/Fiber) LED illuminated?
NO
•
Check fiber cables for proper connection.
•
Verify that TX and RX cables on media converter are connected to
RX and TX ports, respectively, on other media converter.
•
Contact Technical Support: (800) 260-1312.
YES
•
Proceed to step 3.
3.
Is the SDC (Signal Detect/Copper) LED illuminated?
NO
•
Check coax cables for proper connection.
•
Check integrity of device attached to media converter by coax
cable.
•
Contact Technical Support: (800) 260-1312.
YES
•
Contact Technical Support: (800) 260-1312.
Install Slide-In-Module(s)
CAUTION : Wear a grounding device and observe electrostatic
discharge precautions when installing Media Converter Slide-in-
Module(s) in the media conversion center. Failure to observe this
caution could result in damage to, and subsequent failure of, the
Media Converter Slide-in-Module(s).
NOTE: Slide-in-Modules can be installed in any installation slot, in
any order.
To install the Media Converter Slide-in-Module in the CPSMC18xx
chassis:
1.
Remove Media Converter Slide-in-Module protective plate from
selected installation slot by removing two screws that secure
plate to front of CPSMC18xx.
2. Carefully slide Media Converter Slide-in-Module into
installation slot, aligning Media Converter Slide-in-Module
with installation guides.
NOTE: Ensure that the Media Converter Slide-in-Module is
seated firmly against the backplane.
3. Secure Slide-in-Module to CPSMC18xx chassis by rotating
captive screw attached to Slide-in-Module clockwise into
chassis.
CSDTF30xx
5
8
