TransCore AI1401, User Manual

Page: 37 / 42

Firmware Command Groups and Parameters
A-11
Response
!xxxx
where
xxxx
= four-digit decimal number, in the range of 0000 to 1000
Note: This number does not give an indication of the position of the display data
pointer.
or
!Error
Set Reader Power-off Time-out to 10 Seconds
!750
(factory setting)
This time-out is the amount of idle time that elapses before the reader discontinues
operation. Activity on the RS
–
232C port or activating the trigger signal restarts the
timer.
Response
!Done
or
!Error
Set Reader Power-off Time-out to One Minute
!751
This time-out is the amount of idle time that elapses before the reader discontinues
operation. Activity on the RS
–
232C port or activating the trigger signal restarts the
timer.
Response
!Done
or
!Error
Set RF Power-off Time-out
!76x
Sets the amount of time the RF source stays on. The RF source is turned off after the
time-out expires or when the successful acquisition of a tag ID occurs.
where x is