Page 13
o
If the Bluetooth button is off, verify that the device is powered and in
standby mode.
•
On the MySleepDash app, tap continue on the welcome page.
•
Tap the QR code icon to open your camera. You may be required to allow the
device to use the camera features.
•
Locate the QR code on the bottom of the Transcend Micro device and scan using the
camera on your smart device.
•
Click add to complete adding your device.
•
The blue LED light on the Transcend Micro will turn green.
•
Your device is now connected, follow the on-screen prompts on your smart device
to continue setup.
Starting/Stopping Therapy
1.
Connect the Transcend Micro to a power source and allow it to enter Standby Mode.
2.
Be sure your mask fits firmly and in place before starting therapy.
3.
Press the Power button or breathe normally to engage SleepStart. Therapy will
begin when the blower delivers or ramps to the prescribed therapy pressure.
NOTE:
Some masks are configured differently. Due to this variability SleepStart may
not function.
NOTE
:
If therapy is interrupted by a power failure, the device will automatically
restart therapy once power is restored.
Using the Ramp Function
The Ramp feature lets you acclimate to air flow by starting at a lower pressure and
gradually increasing to the prescribed pressure setting as you fall asleep.
To accelerate the rate of the pressure increase during Ramp mode:
•
Hold the Ramp button down until the device reaches a comfortable therapy
pressure.
•
When the Ramp button is released, the device will continue in Ramp Mode until it
reaches the prescribed therapy pressure.
•
To end Ramp early, hold down the Ramp button until the prescribed therapy
pressure is reached.
•
If Ramp is no longer desired, disable it via software. Or disable auto-ramp by
pressing the Ramp button when in standby.
NOTE:
To adjust ramp starting pressure or duration see the Transcend Micro
software manual available on the Transcend website (mytranscend.com).
Summary of Contents for Micro
Page 1: ...Micro User Manual ...
