Page 2-1
CHAPTER 2: GETTING STARTED
After unpacking the scale, a small amount of preparation is required before the scale can be used for
mailing or shipping. Please refer to Figure 2-1 below as needed.
INTERFACE
PORT
POWER
CONNECTOR
ON/OFF
SWITCH
Figure 2-1: SPS-70 / SPS-150 Back Panel
Step 1. Position the scale in its area of intended use. Observe the following guidelines for suitable
location.
1. Choose a firm, stable floor or table.
2. Do not share an AC outlet with electrical noise producing equipment, such as refrigeration
units. This includes products with electrical motors and/or relays.
3. Do not place the scale in an area with changing ambient temperature and/or high humidity.
4. Do not place the scale in an area prone to exposure to direct sunlight, wind, or dust.
5. Do not place the scale in an area with vibrating equipment.
Step 2. Install the AC Adapter.
1.
After placing the scale in its area of use, locate the Model A41408 AC Adapter.
2.
Connect the female end of the AC Adapter to the connector on the rear of scale, and then
plug the adapter into an AC outlet.
Step 3. Turn the scale’s AC power on to begin the initialization.
Step 4. Initialization - The first time the scale is turned on you will be required to enter your origin ZIP
Code.
1.
When the AC power switch is placed “ON” position, the scale prompts for your “origin ZIP
Code”.
2.
Enter the first three digits of your ZIP Code. The scale displays the ZIP Code entered and
prompts you to verify (Yes or No) if the ZIP Code displayed is correct.
3.
If the ZIP Code is correct, press the “Yes” (Enter) key to complete the initialization or if the
ZIP Code is incorrect, press the “No” (Clear) key and enter the correct ZIP Code.
