Trango 22840-100, Quick Start Manual

Page: 4 / 20

4
mounting instructions (con’t)
STEP 1: Locate a suitable area.
For the simplest option, find a doorway with sufficient space on both sides and
above the door frame. You should have enough room to allow your elbows,
hands, and body to avoid touching anything other than the training center.
Make sure there are no hazards such as stairs or other obstacles nearby. You
also must maintain a minimum of 4” from the bottom of the rail cleats
4” clear area
required below
the cleat
STEP 2: Determine if you will use a Mounting Board behind Rail Cleats.
The Rail Cleats for the Pivot are 18” in length so you may attach them to standard stud
widths of 16” on center. This is not the case in all locations where the Pivot might be
mounted. Please make the determination that is the safest for the you the user.
STEP 3: Attach the Rail Cleats to your wall or go to Step 6 if using a mounting board.
The two pieces should be placed at the exact same height. Many people will choose
to put them together to make a continuous rail. Make slight adjustments to the spacing
and orientation of each piece as desired for optimal comfort, considering the shoulder,
elbow and finger joints. The Rail Cleats have a sticker indicating correct orientation
for mounting. The slanted angle should be facing towards the wall and on top.
STEP 4: Attach Set Screws to Pivot Board.
Your Rock Prodigy Pivot comes pre-attached the Quad Cleat mounting system. For
final installation make sure that Flat Head Bolt is securely fastened and set the
final angle of the board based on your personal comfort level. Please remember
that the board will be used in all 4 axis. Most people will choose to have the
Pivot mounted horizontal on the Quad Cleat. Use the 1 1/4” screws.